Opel Insignia: Heating, Ventilation, and Air Conditioning
Opel Insignia B 2018-2025 Service Manual / HVAC & Restraints / Heating, Ventilation, and Air Conditioning
- Specifications, Visual Identification
- Diagnostic Information and Procedures
- Repair Instructions
- Special Tools and Equipment
READ NEXT:
Specifications, Visual Identification
SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with
NEW after removal.
Applicat
Diagnostic Information and Procedures
LEAK TESTING
Special Tools
GE-41447 A/C Tracer Dye-Box of 24
GE-42220 Universal 12V Leak Detection Lamp
GE-43872 Fluorescent Dye Cleaner
GE-50078 Electronic Leak Detector
GE-50744 R-1234yf PAG O
Repair Instructions
Odor Correction
Eliminating Air Conditioning (A/C) Odor
Odors may be emitted from the heat and air conditioning system primarily at
start up in hot, humid climates.
When the blower motor fan is turn
SEE MORE:
Pre-Alignment Instructions
NOTE: This is GENERAL information. This article is not intended to be
specific
to any unique situation or individual vehicle configuration. For modelspecific
information see appropriate articles where available.
GENERAL ALIGNMENT CHECKS
Before adjusting wheel alignment, check the following:
Each
Description and Operation
Turbocharger System Description
Turbocharger Description and Operation
A turbocharger is a compressor that is used to increase the power output of
an engine by increasing the mass of the
oxygen and therefore the fuel entering the engine. A turbocharger is mounted
either to the exhaust manifold or
© 2019-2025 Copyright www.opinsb.com
