Opel Insignia: Tires and Wheels
Opel Insignia B 2018-2026 Service Manual / Suspension / Tires and Wheels
READ NEXT:
Specifications, Diagnostic Information and Procedures
SPECIFICATIONS
FASTENER SPECIFICATIONS
Reusable Threaded Fastener Tightening Specifications
NOTE:
All Fasteners Listed In This Table Can Be Reused After Removal.
ADHESIVES, FLUIDS, LUBRICANTS, AND SE
Repair Instructions
Aluminum Wheel Porosity Repair
1. Remove The Tire And Wheel.
2. Inflate The Tire To The Pressure Stated On The Tire Placard.
3. Submerge The Tire/Wheel Into A Water Bath In Order To Locate The Leak
Description and Operation
Metric Wheel Nuts and Bolts Description
Metric Wheel Nuts And Bolts Are Identified In The Following Way:
The Wheel Nut Has The Word Metric Stamped On The Face.
The Letter M Is Stamped On The End Of
SEE MORE:
Specifications, Schematic Wiring Diagrams
SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW after removal.
Application
Brake Hose Fitting Gasket
Brake Pedal Retainer
Master Cylinder Seal
Single Use Threaded Fastener/
Description and Operation
ELECTRONIC SUSPENSION CONTROL DESCRIPTION AND OPERATION
K19 - K19 Suspension Control Module
B161LF - B161LF Vertical Suspension Acceleration Sensor - Left Front
B161RF - B161RF Vertical Suspension Acceleration Sensor - Right Front
B162RF - B162RF Vertical Body Acceleration Sensor - Right Front
B162
© 2019-2026 Copyright www.opinsb.com
